FrSky Archer RS

4 reviews
Regular price$23.15
/
Shipping calculated at checkout.

  • In stock, ready to ship
  • Inventory on the way

FrSky's super tiny SBUS ACCESS receiver.

The FrSky Archer RS takes the existing RXSR and increases its potential with the addition of the new and exciting ACCESS RF protocol. Users can expect Over The Air firmware updates (OTA), longer range with less latency and faster telemetry. It also features dual removable antennas as well as an inverted S.Port, allowing for easy integration into most flight controllers. Use it as a redundant receiver when coupled with any other SBUS capable FrSky ACCESS receiver, the setup will automatically use the receiver with the best signal.

Features:

  • ACCESS protocol with Over The Air (OTA)
  • Tiny and super lightweight
  • Supports signal redundancy (SBUS In)
  • Full control range with telemetry
  • S.Port / F.Port
  • Inverted S.Port
  • Plug in picture included (NOT ASSEMBLED)

Specs:

Dimensions 16 x 11 x 2.5mm
Weight 1.3
Number of Channels 16 SBUS Channels
Voltage Range 3.5-10V
Operating Current <60mA@5V
Range >2km, range may vary based on local conditions.)
Compatibility All FrSky ACCESS Transmitters
FrSky Archer RS
FrSky Archer RS

Customer Reviews

5.0 Based on 4 Reviews
5 ★
100% 
4
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
100reviewers would recommend this product
Write a Review Ask a Question

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
KC
Kerry C.
United States
I recommend this product
06/29/2022

working fine

Does what it is supposed to! I used heat shrink to insure the antenna stays in place and to stick velcro onto for mounting.

K
KC
United States United States
I recommend this product
06/05/2022

it's small.

And is doing a great job. I am using it as a remote in a sailplane. I tested by unbinding the main rx and temporarily turned on the telemetry for the RS then range tested. The RS passed with flying marks.

AS
Atomic S.
United States United States
09/14/2021

Good small reciever

The pitch of the PCB holes is 2mm NOT 2.54mm so you cannot use standard servo plugs with the provided pin header. A JST-SH connector will fit perfectly or you can acquire a proper JST-SH socket and install that. If you direct solder the wires about the maximum size you can use is 24 AWG, 22 AWG is too fat.

A
Anonymous
United States United States
09/02/2021

I am flying further now with stronger or SSI readings using the RS receiver as a redundant located in the tail

My confidence is higher in my radio connection I can fly further Than I have ever flown