You have no items in your shopping cart.

Product was successfully added to your shopping cart.
FrSky SBUS & CPPM Decoder with Pins

FrSky SBUS & CPPM Decoder with Pins

Regular Price: $11.10

Special Price $10.66

(Out of stock)

FrSky SBUS & CPPM Decoder with Pins

Quick Overview

The FrSky SBUS & CPPM Decoder allows you to connect normal servos to your SBUS or CPPM systems.

Regular Price: $11.10

Special Price $10.66

Availability: Out of stock


The FrSky SBUS & CPPM Decoder can be used to decode SBUS or CPPM signals and converts them to PWM signals for use with conventional analog and digital servos.

SBUS Decoder

Compatible with receivers that feature the SBUS port. Some examples are the FrSky TFRSB 9TFR4SB, TFR8SB) and X series (X8R, X6R) receivers and the Futaba S.BUS receivers (R6208SB, and others) as well as tools like the FrSky SBUS Servo Channel Changer and the Futaba SBC-1.


Channel Output Cable Lengths: 210mm
Total length: 350mm
Operating Temperature Range: -10-80℃
Operating Voltage Range: 4-10V
Compatibility for SBUS Connection Port: FrSky SBUS Servo Channel Changer, FrSky TFR8SB receiver, Futaba SBC-1 or Futaba S.BUS receivers (R6208SB, etc.)
Compatibility for PWM Connection Ports: digital servos

NOTE: Will pass the Sbus framerate to the servo (PWM) output. Typically this will be about a 9ms frame rate, these faster frame rates will work best with digital servos, though some analog servos appear to be OK.

  1. Great sbus decoder review by David on 3/8/2016

    I had one of these on hand for some time and had never had a need till recently. I needed one more pwm channel than my receiver supported. Assigned the channel easily and it works perfectly. Will always keep one or two of these on hand. Far preferable over using two receivers to get additional channels. This would be especially great for remote groups of servos.

  2. Light compact , will be buying more review by Ravi on 8/4/2015

    I'm using these in my planes and use one x4r moved from plane to plane. Why? Just because I can:) remember to change the channel assignments using a servo ID changer. For example pin set 1 can be assigned channel 4, pin set 2 channel 12.

  3. Very handy product. review by Hans on 9/22/2014

    I put this in wings that have more channels. One wire to hook up for 4 channels in a wing. I use 2 of them in a spitfire wing. I use 2 channels for the ailerons, 2 channels for the flaps, and 2 channels for the gear. This way the gear can be extended one a little later than the other like the full scale spitfire. The ailerons and each flap can be fine tuned separately. I did run an extra wire to make sure that the current of 6 separate servo's was not too much for the thin wire on the FrSky SBUS & CPPM Decoder. It would be nice to have a heavy wire on this unit, that is my only suggestion.

Write Your Own Review

Only registered users can write reviews. Please, log in or register