The Nighthawk-X4, X5, and X6 are EMAX’s first X framed race quads, with equidistant motor placement and centrally located mass for the ultimate in balance and agility. For a ultra clean build, Emax has included a custom PDB in the design, with Dual Shielded Voltage Regulators, integrated XT60 battery connector, low voltage buzzer and programmable LED strip. The built-in PDB serves as the top half of the main structural frame, eliminating the need for another carbon plate, which saves precious weight. With all the components arranged near the frames center of gravity, the NX4 is very agile and quick to respond.
Optional arms allow you to change the frame size from 4” to 5" or 6". The Nighthawk-X6 (6” frame) “All-Up-Weight” is less than 490g with a 1000mah 4s battery, and can achieve a high thrust to weight ratio.
The adjustable HD Camera Mount bolts onto the top plate. The mount can swivel from 30-45 degrees allowing you to set your prefered camera angle.
The Nighthawk X4 frame comes with 4 inch arms. You can change the frame to either the 5 or 6 inch model by purchasing the appropriate arms from the list above. The arms are sold individually.
Change from 175, 200, or 240mm sized frame by simply swapping out arms.
Narrow width of the arms presents less drag and obstruction to thrust.
Unique motor plate design lets the user install original EMAX Nighthawk Motor Guards.
3mm thick arms - available in 4" length
1.5mm Bottom Carbon Fiber plate
1.5mm Top Carbon Fiber plate
PDB Power Output: Filtered 12V @ 2A and 5V @ 3A Switching Regulators
3 Programmable RGB LEDs (Runs on 5V)
* - Weight includes all frame hardware.