We are SHIPPING ORDERS, and answering emails!
Sorry, our showroom is closed due to the virus.

Zepsus Magnetic BEC 5A

5 2

Designed for DLG and HLG model gliders. Lightweight BEC, less than 5g. Super slim design to fit in small fuselages. Extremely high quality!

  • The Zepsus Magnetic BEC was designed with one thing in mind, we must not compromise on quality. With that said, the best components have been selected. No cheap solutions, this is the best of the best all the way around.

    A clean and easy way to turn on your model, just slide the magnet across the switch. Switches can be mounted inside of the fuselage, out of the air stream, and the magnet will easily activate the switch from outside. No more fumbling for little switches, or plugging in connectors.

    Four reasons to buy the Zepsus Magnetic BEC

    • The Magnetic BEC has the same well-known and well-tested magnetic technology as the Zepsus Magnetic Switches.
    • If a servo burns out in flight, the extreme high peak current will help the Magnetic BEC provide power to continue the flight and burn the servo electronics. Other BEC's will give up, resulting in a crashed plane.
    • No buck or boost converter. No charge pump. No switching noise. This makes the Zepsus Magnetic BEC a ultra low noise product suitable for radio controlled gliders where a long range is very important.
    • Ultra low dropout voltage provides security if a battery cell collapses and input voltage suddenly drops below the selected output voltage.

    Calculation example of continuous current:
    Max power loss continuously / (Input voltage – Output voltage) = current continuously

    2S Lipo nominal voltage 7.4V and output voltage is 5V.
    3 / (7.4 – 5) = 1.25A

    Price includes
    BEC and 1 Magnet

    Length 25cm (incl cables)
    Dimensions 40 x 15 x 5mm (incl heat shrink)
    Weight 4.9g (incl cables)
    Connector Type JR-type
    Wire Gauge high-quality 0.25mm2 (AWG 23)
    Operating Temperature -40C to +125C
    Operating Voltage 3~10V (designed for 2s Lipo/Liion/LiFe or 5s NiMH/NiCD batteries)
    Burst Current >20A (depending on input/output voltage)
    Output Voltage 5V
    Output Current 5A
    Standby Current Consumption 6µA (micro-ampere)
    Dropout Voltage 72mV@4A (If input voltage drops below output voltage)
    Max Power Loss Continuous 3w
    Max Power Loss Burst >20w