This switch is designed for DLG and HLG remote controlled gliders. This power switch is super lightweight. If the cables are shortened to 10 cm, normal installation length, the total weight is less than 2g. With this switch, your model can be turned on or off without you needing to access it internally. Just move a magnet over the switch, on the outside, and it turns on. To turn it off just pass the magnet by the switch again. The switch has an ultra low standby power consumption in the off-state. The consumption is so low that the switch can be connected to a 300mAh battery for several years without discharging it. The switch has a built-in failsafe function. It remembers its state for at least 10 sec, if disconnect from the battery. It will protect the switch against power glitches caused by bad battery connections, etc.
All switches have been tested with 4A for 30 sec before delivery. Standby consumption is controlled and a visual inspection is made.
Magnet and Stickers
|Standby Current Consumption||5µA (micro-ampere)|
|Dimensions||25 x 7 x 3mm / 0.98 x 0.28 x 0.12 in|
|Weight||1.75 grams / 0.06oz|
|Wire Gauge||high-quality 0.25mm2 (AWG 23)|
|Operating Temperature||-40C to +50C|